Vna6000p

VNA6000P is a Portable, full 2-port 6 GHz VNA Main Features ✔ Frequency range: 1 MHz to 6 GHz ✔ Full two-port VNA: both ports can function as transmitter and receiver which allows to measure all four S-parameters without physically switching the DUT ✔ Above capability allows the implementation of standard VNA calibration procedures. Currently implemented procedures are 1-port OSL, 2-Port OSLT, 2-Port LMR16 and Transmission normalization for S21/S12. Industry standard models of calibration standards (separately for male and female connectors) are supported ✔ Due to architecture of this VNA, only one S-parameter can be measured at the time. Separate 1-Port and 2-Port modes are implemented. In 1-Port mode only S11 or S22 is measured which allows for faster trace update. In 2-port mode trace is updated after all 4 parameters are measured successively ✔ Currently two traces can be displayed simultaneously which can be set to combination any of four S-parameters and different data representations which includes: Log magnitude, Linear reflection coefficient, Impedance, VSWR, Phase, Group Delay. Trace display range and Ref. level can be changed for all formats ✔ Time Domain(TD) function is available in 1-Port mode. Implemented TD modes: Band- Pass impulse, Low-Pass impulse ans Low-Pass step. It is possible to zoom and interpolate data in time axis for increased resolution ✔ Smith chart display is available which can be displayed simultaneously with Cartesian traces ✔ Two scrollable trace markers are available which includes 'Delta' function as well ✔ User can save data to Micro-SD card. Available data formats are BMP screen-shots, S- parameters (S1P or S2P files) and OSLT calibration coefficients. SD card also contains description of calibration standard model coefficients. ✔ Internal ('factory') calibration allows to do quick 1-Port/2-Port measurements without mechanical calibration ✔ Zero span option allows to use VNA as simple signal generator (unfiltered and level uncalibrated). On-board step attenuator allows to change signal power in range of 31.75 dB with steps of 0.25 dB ✔ All main settings, when changed, are automatically saved in on-board EEPROM ✔ VNA is powered from single 3200 mA Li-Po cell or +5 to +12Vdc wall adapter and includes circuit for automatic battery charging. Approximate battery life ranges from 3 to 4 hours depending on measurement mode (on 1-Port mode one channel can be powered off). Current consumption is operational mode is ranges from 600 to 700 mA, but in sleep/power off mode less is than 100 uA